NORAUTO RECOVERY Bedienungsanleitung Seite 138

Connecting the charger and charging the Battery with the Terminal Rings
IMPORTANT: Before start connecting, unplug the battery Charger AC cord from the AC
outlet. Disconnect the battery clamps from the unit at output cord connector.
The charger's battery eyelets are color-coded (RED-POSITIVE and BLACK-NEGATIVE).
NUT
CONNECTOR
1. Remove the nuts from the bolts of the battery post's
connectors.
2. Position the red terminal ring on the bolt of the positive
battery post connector.
3. Position the black terminal ring on the negative battery
post connector; then replace the nuts.
Connect the battery eyelet connector to the unit
connector, as far away from the battery as possible.
1
TERMINAL RING
BOLT
2
Plug the unit to the power socket.
* The charger remains in Float Charge Mode as long
as the charger is connected to the battery and is
plugged into a functioning AC mains socket.
Press CHARGER button, to select the charging voltage
mode (12V or 24V) according to the battery voltage.
Attention: Please wait for few seconds to toggle the
12V or 24V charging mode by pressing the button.
138
3
4
To Start the Charging