The tool is now fully clamped in the hydraulic chuck and can be used.
5 5 . . 2 2 U U n n c c l l a a m m p p i i n n g g a a t t o o o o l l
W W A A R R N N I I N N G G
U U n n c c l l a a m m p p i i n n g g a a t t e e x x c c e e s s s s i i v v e e c c l l a a m m p p i i n n g g c c h h u u c c k k t t e e m m p p e e r r a a t t u u r r e e s s ! !
Unclamping at excessive clamping chuck temperatures can cause parts of the hydraulic chuck to fly off uncontrolled, al-
lowing hot oil to escape. This can lead to serious injuries and cause damage to machines and accessories.
Actuate the clamping screw of the hydraulic chuck only at room temperature.
Montage- und Betriebsanleitung
Montage- und Betriebsanleitung
Installation and Operating Instructions
Installation and Operating Instructions
I I N N F F O O R R M M A A T T I I O O N N
The clamping screw is not captive!
Ensure that the clamping screw is clean.
Turn the clamping screw u u p p t t o o t t h h e e s s t t o o p p using an hex-wrench with T-
Fig. 11: Clamp the tool
handle (see
Set a torque wrench to a tightening torque of 7 7 N N m m .
Tighten the clamping screw to the stop with the aid of the torque