Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4 4 . . 5 5 C C h h e e c c k k i i n n g g t t h h e e c c l l a a m m p p i i n n g g f f o o r r c c e e
The minimum number of rotations are indicated on the hydraulic chuck (see
check of the clamping force. This ensures that the minimum transferable torque is achieved at each clamping operation.
The minimum number of rotations are the number of rotations of the clamping screw that have to be achieved from the
gripping point of the shank up to the stop of the clamping screw. The gripping point is the position of the clamping screw
in which the tool shank can no longer be turned with two fingers or pulled out of the location bore.
5 5
O O p p e e r r a a t t i i n n g g t t h h e e h h y y d d r r a a u u l l i i c c c c h h u u c c k k
5 5 . . 1 1 C C l l a a m m p p i i n n g g a a t t o o o o l l
I I N N F F O O R R M M A A T T I I O O N N
Actuation of the stop screw of the hydraulic chuck is possible from both sides.
W W A A R R N N I I N N G G
S S h h r r i i n n k k i i n n g g o o r r h h e e a a t t i i n n g g t t h h e e h h y y d d r r a a u u l l i i c c c c h h u u c c k k c c a a n n l l e e a a d d t t o o i i n n j j u u r r i i e e s s a a n n d d d d a a m m a a g g e e t t o o m m a a c c h h i i n n e e s s a a n n d d a a c c c c e e s s s s o o r r i i e e s s ! !
Shrinking or heating can cause the hydraulic chuck to become deformed or to burst explosively. Hot oil, oil
vapours and metal slivers can then fly around uncontrolled and cause serious injuries to the operator and
cause damage to machines and accessories.
Do not shrink the hydraulic chuck or heat it above the specified operating temperature.
Montage- und Betriebsanleitung
Montage- und Betriebsanleitung
Installation and Operating Instructions
Installation and Operating Instructions
section 4.2
) and provide a simple and reliable
EN
EN
41
41
Werbung
