Mapal hydraulic chuck Montage- Und Betriebsanleitung Seite 43

Inserting tool
N N O O T T I I C C E E
D D a a m m a a g g e e f f r r o o m m f f a a i i l l u u r r e e t t o o o o b b s s e e r r v v e e t t h h e e m m i i n n i i m m u u m m c c l l a a m m p p i i n n g g d d e e p p t t h h i i n n t t h h e e h h y y d d r r a a u u l l i i c c c c h h u u c c k k ! !
 Observe the prescribed values for the minimum clamping depth
Tab. 2: Technical data [mm]
(see
N N O O T T I I C C E E
D D a a m m a a g g e e c c a a u u s s e e d d b b y y t t o o o o l l l l e e n n g g t t h h a a d d j j u u s s t t m m e e n n t t w w i i t t h h c c l l a a m m p p e e d d t t o o o o l l ! !
 Do not change the tool length adjustment as long as the tool is clamped.
Montage- und Betriebsanleitung
Montage- und Betriebsanleitung
Installation and Operating Instructions
Installation and Operating Instructions
Push the tool, shank first, to the stop screw in the location bore in the
hydraulic chuck.
).
EN
EN
43
43