Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4 4 . . 4 4 T T e e c c h h n n i i c c a a l l d d a a t t a a
W W A A R R N N I I N N G G
F F a a i i l l u u r r e e t t o o o o b b s s e e r r v v e e t t h h e e t t e e c c h h n n i i c c a a l l d d a a t t a a a a n n d d m m a a x x . . r r o o t t a a t t i i o o n n a a l l s s p p e e e e d d ! !
Failure to observe the technical data can result in serious injury to the operator and in machine damage.
Observe the technical data given in
During clamping, screw in the clamping screw up to the stop, observing the specified minimum number of rotations.
Observe the prescribed values for the minimum clamping depth.
The max. rotational speed of the machine spindle connection is to be
Observe the prescribed spindle speed limits for the machine-side connection.
Observe the maximum load limit for the machine-side connection in accordance with e.g. VDMA 34181.
If irregularities occur during operation, do not use the hydraulic chuck further for safety reasons and send it to
MAPAL for inspection or repair.
• General technical data:
• Material 1 1 , , 6 6 0 0 0 0 N N / / m m m m ² ² .
• Hardness 5 5 2 2 + + 2 2 H H R R c c .
• Tool holders balanced as standard.
• Operating temperature 2 2 0 0 t t o o 8 8 0 0 ° ° C C .
• Coolant pressure maximum 8 8 0 0 b b a a r r .
• Maximum adjustment path 1 1 0 0 m m m m .
• Cylindrical shanks, with and without reducing sleeves, with shank tolerance h h 6 6 according to D D I I N N 1 1 8 8 3 3 5 5 forms A, B,
E and according to D D I I N N 6 6 5 5 3 3 5 5 forms HA, HB and HE can be clamped.
• Specification for checking of the clamping force (see
Montage- und Betriebsanleitung
Montage- und Betriebsanleitung
Installation and Operating Instructions
Installation and Operating Instructions
section 4.4
.
sections 4.2 and 4.5
maintained.
).
EN
EN
39
39
Werbung
