Elettro 205 STANDARD Bedienungsanleitung Seite 26

Setting PULSE time
Press button SET until you switch on LED marked in the picture.
Use the potentiometer to set up required value of interval time between
particular 0.2-2 seconds.
Setting four-stroke welding mode
Press button FNC until you switch on LED.
Mode four-stroke is adjusted.
Setting four-stroke SPOTTING
Press button FNC until you switch on two LED four-stroke and SPOTTING in
the picture.
Mode four-stroke spotting is adjusted.
Setting four-time PULSE mode
Press button FNC until you switch on two LED four-stroke and PULSE in the
pic.
Mode four-stroke pulse is adjusted.
Function MEM (only with machines PROCESSOR)
Function enables back recall and display of last welding parameters for a
period of about 7 seconds.
Press button MEM
Display will show last measured values of welding voltage and current for 7
seconds. Values can be recalled repeatedly.
Function SYNERGIC (only with machines SYNERGIC)
Function SYNERGIC simplifies operating and adjustment of welding para-
meters. Operating staff can specify type of program through a simple setting
of gas type and wire diameter. To set welding parameters you can set simply
and easily voltage with a switch and electronics will adjust speed of wire
shift automatically.
26 | EN
Switching on function SYNERGIC
Press button SYN until you switch on LED SYN and LED material thickness.
Function SYNERGIC is on.
Program choice - adjustment of wire diameter and gas type
Press button SET until you switch on LED marked in the picture.
Using the potentiometer, you shall choose gas type you are going to apply
- CO or Ar (marks MIX argon and CO
2
Press button SET until you switch on LED diode marked in picture.
Use the potentiometer, thus you shall choose wire diameter SG2 you are
going to use - 0.6 - 0.8 - 1.0 mm.
Approximate thickness of material possible to weld according to current ad-
justment will be shown on upper display. Currently adjusted speed of wire
shift will be shown on bottom display, which is changed automatically when
you change positions of voltage switch. Fall or rise in welding capacity is
adjustted with a voltage switch.
gas in ratio 18 CO and the rest Ar.
2 2