Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Control apparatus
1
2
3
4
5
Picture 1A - types 2200, 2400
1
2
3
4
5
Picture 1B - types 205, 225, 245
Position 1 10 - positional voltage change - over switch.
Position 2 Supply switch. In the „0" position the welder is off.
Position 3 Switch of SPOT function with potentiometer of spot time adjus-
tment (STANDARD only).
Position 4 EURO connector of welding burner connection.
Position 5 Gladhand of earth cable.
Position 6 Potentiometer of speed adjustment of wire feed (STANDARD
only).
Position 7 Switch of DELAY function with potentiometer setting delay time
between particular spots, slow pulses and switch of two-stroke
and four-stroke functions (STANDARD only).
8
9
Picture 2
Position 8 Gas inlet into electromagnetic valve.
Position 9 Terminal board of voltage supply for gas 24 V AC heating.
Position 10 Adaptor of wire spool.
Table 2
I Max
Installed power
Protection slow, char. D
Imput cable cross-section
Earth cable cross-section
Welding torch
22
|
EN
6
7
6
7
13
12
11
10
205
[ A ]
190 (15 %)
[ kVA ]
7.6
[ A ]
16
[ mm
]
4 x 1.5
2
[ mm
]
16
2
-
Position 11 Wire spool holder with brake.
Position 12 Introduce spring.
Position 13 Introduce tube of EURO connector.
Control panel PROCESSOR
10
9
8
7
6
5
3
4
1
2
Picture 3
Position 1 Potentiometer for setting parameters.
Position 2 Button TEST OF GAS.
Position 3 LED signalizing choice of adjustment of pre-gas.
Position 4 LED signalizing choice of setting start time of welding wire spe-
ed.
Position 5 Button SET - it allows choosing setting parameters.
Position 6 LED illustrates switching on of pulse function.
Position 7 Button welding mode - it allows switching on and off of two-
-stroke and four-stroke modes, spot and pulse welding.
Position 8 LED illustrating spot welding mode.
Position 9 LED illustrating four-stroke welding mode.
Position 10 Button MEM allows loading of values of voltage and welding
current which were measured last time.
Position 11 LCD of welding current.
Position 12 LCD showing welding voltage and values with LED SETTING light
up. They are values of speed of wire feeder, pre-gas etc.
Position 13 LED SETTING which lits only while setting parameters: speed of
wire feeder, start of wire, pre-gas and post-gas, spot time and
pulse time, burning out of wire.
Position 14 LED illustrating choice of speed adjustment of welding wire
feed.
Position 15 LED illustrating choice of setting spot time LED.
Position 16 LED signalizing choice of burning out time adjustment.
Position 17 LED illustrating post-gas time.
Position 18 LED signalizing choice of setting pulsation time.
Position 19 Button for wire feeding.
245
195 (25 %)
8.6
16
4 x 1.5
25
KTB 15
2200
2400
190 (30 %)
215 (40 %)
7.6
9.7
16
16
4 x 1.5
4 x 1.5
16
25
11
12
13
14
15
16
17
18
19
Werbung
Kapitel
Inhaltsverzeichnis
