Quick Start - Megasat Countryman GPS Professional Benutzerhandbuch

2. Operating instruction
Description
1. Take out the antenna from carrying case, and place it on the flat ground (or mount it on
the top of the camper) facing South & no obstacle.
2. Connect the left port of the antenna, which located at the rear of the main unit, to the
controller using controller cable.
a) One end of the controller cable connect to „controller" port of the main unit of
Settings the antenna.
& b) The other end of the controller cable connect to the port of the controller.
Connecting 3. Connect the power cable to controller.
a) If you use the power source from a car or caravan etc, use the cigarette lighter
adaptor to connect the power to controller.
b) Otherwise use a suitable 12 Volt DC adaptor to connect the power to controlle.
4. Connect between the right port of the antenna, which located at the rear of the
main unit, to the receiver using receiver cable..
1. Switch on with the "Power switch" button on the top of the controller.
2. Upon power on, all LED will flash twice.
3. Wait until "HOME Status" light & one "Satellite LED" light, which you set previously or the
first satellite in the controller (Turksat), remain solid on.
Operation 4. Select the desired satellite using the "CCW / CW" buttons, then press the "OK" button to
(Search satellites) select.
5. IF the satellite LED light starts flashing, please wait for a while until it turns to keep the LED
on steadily.
6. When the satellite LED light stays on, the selceted satellite has been located and a signal
can be seen on the satellite TV.
When you move the car, the flat dish of the antenna must be at the
Home position.

Quick Start

ENGLISH
09