Appendix; Troubleshooting; Specifications - Korg LP-380 Bedienungsanleitung

Troubleshooting

If during use any of the following problems should occur,
carefully examine the instrument to see if you can find out
what the problem is, and try resolving it by following the
suggestions below. If the instrument will still not function
properly refer to your dealer.
The instrument will not turn on
• Check that the AC adapter is correctly connected to the
piano and the outlet.
No sound
• Is the speaker cord of the speaker box on the stand con-
nected with the speaker connector on the LP-380 cor-
rectly?
• Make sure that the volume is not set on MIN. If it is,
bring it up to an adequate level.
• Make sure that the MIDI Local function is not set on
OFF. If it is, set it to ON (or turn the instrument off and
then on again).
• Make sure there is not a jack plugged into one of the
Headphones jacks. This would turn the internal speak-
ers off. if so, unplug the jack.
Notes are interrupted
• You have exceeded the maximum polyphony. see
"About maximum polyphony."
The pitch or tone of the piano sounds wrong in some
key regions
• The LP-380's piano sounds replicate the sound of an
actual piano as faithfully as possible. This means that
in some regions of the keyboard, you may feel that
the overtones seem stronger, or that the tone or pitch
seems wrong. This is not a malfunction.
The connected MIDI application does not respond to
MIDI data that you transmit.
• Make sure that the USB cable is connected correctly.
Please make sure that the LP-380 is set to the same
MIDI channel as your MIDI application, and that the
LP-380 is receiving MIDI data.
About maximum polyphony
If the number of notes being played simultaneously ex-
ceeds the maximum polyphony, some notes will be lost
since the LP-380 is equipped with a mechanism that stops
the first note being played to give priority to notes played
with keys pressed later. Some LP-380 sounds, although
they may be a single sound, are generated by two or more
oscillators (one note of a sound-generating circuit). Sounds
using just one oscillator, such as those in banks 1 and 2 of
VIBES/GUITAR, have a maximum polyphony of 120 notes.
Sounds using two oscillators, such as those in banks 1 and
2 of PIANO2 and in banks 1 and 3 of E.PIANO2, have a
maximum polyphony of 60 notes.
120 ÷ Number of sound oscillators = Maximum polyphony
Keep the maximum polyphony in mind and carefully
choose sounds when using Layer mode to play two sounds
simultaneously or when using the damper pedal.
16

Appendix

Specifications

Keyboard
Touch selection Light, Normal, Heavy
Pitch
Temperament
Sound generation Stereo PCM System
Polyphony
Sounds
Effects
Demo
Metronome
Tempo, Time signature, Accent, sound and Volume
controls
Pedal
Damper*, Sostenute, Soft* (*half-pedaling supported)
Connections
LINE OUT jack, USB port (Type-B), Headphone jack×2,
PEDAL jack, SPEAKER jack
Controls
Power, VOLUME, PIANO SONG, TRANSPOSE,
FUNCTION, TOUCH, BRILLIANCE, REVERB,
CHORUS, BANK, Sound × 10, UP, DOWN,
METRONOME
Amplification
Sperkers
Power supply
Power consumption
Dimensions (W × D × H)
Weight
Included accessories
AC adapter (
Owner's Manual
• Specifications and appearance are subject to change
without notice for improvement.
RH3 (Real weighted hammer action 3)
keyboard: 88 note (A0–C8)
Transpose, Fine tuning
Nine kinds
120 notes (max)
30 sounds (10 x 3 banks)
Brilliance, Reverb, Chorus (3 levels each)
30 (Sound demo song x 10, Piano Song x 20)
22 W × 2
10 cm x 2
DC 19 V, 3.42 A
AC adapter (included)
15 W
1355 × 351 × 772 mm / 53.35 × 13.82 × 30.39 inches
1355 × 351 × 936 mm / 53.35 × 13.82 × 36.85 inches
(with the key cover opened)
37 kg / 81.57 lbs. (including Stand)
), Power cord, Stand, Pedal unit,