5. Transport, packaging and storage
5.2 Packaging and storage
Do not remove packaging until just before mounting.
Keep the packaging as it will provide optimum protection during trans-
port (e.g. change in installation site, sending for repair).
Permissible storage temperature
-40 ... +70 °C
6. Commissioning, operation
WARNING!
Physical injuries and damage to property and the
environment caused by media escaping under high
pressure
With the pressurisation of the instrument, as a result of
poor sealing of the process connection, media under high
pressure can escape.
Due to the high energy of the media that can escape in
the event of a failure, the possibility of physical injuries and
damage to property exists.
The sealing of the process connection must be carried out
▶
expertly and checked for leak tightness.
6.1 Mechanical connection
In accordance with the general technical regulations for pressure gauges
(e.g. EN 837-2 "Selection and installation recommendations for pressure
gauges").
Instruments must be grounded via the process connection.
Operating instructions capsule pressure gauge, model 63x.50 per ATEX
EN
19