Troubleshooting; Transport And Storage; Additional Information - Tunturi Cardio fit T30 Benutzerhandbuch

To set running belt tracking (fig. F-5)
A 10 mm Allen wrench is provided to adjust the
rear roller. Make tracking adjustments from the left
side only. Set belt speed at approximately 3 to 5
kph.
Remember, a small adjustment can make a
dramatic difference!
Turn the bolt clockwise to move the belt to the
right. Counterclockwise to move to the left. Turn
the bolt only a 1/4 turn and wait a few minutes
for the belt to adjust itself. Continue to make 1/4
rotation turns until the belt stabilizes in the center
of the running deck.
The belt may require periodic tracking adjustment
depending on use and walking/running
characteristics. Some users will affect tracking
differently. Expect to make adjustments as required
to center the tread-belt. Adjustments will become
less of a maintenance concern as the belt is used.
Proper belt tracking is an owner responsibility
common with all treadmills.
‼ NOTE
• Damage to the running belt because of
incorrect running-belt adjustments is not
covered by the products warranty.

Troubleshooting

Despite continuous quality control, defects and
malfunctions caused by individual components
may occur in the equipment. In most cases it's
unnecessary to take the whole device in for repair,
as it's usually sufficient to replace the defective
part.
If the equipment does not function properly during
use, contact your Tunturi dealer immediately.
Always give the model and serial number of your
equipment. Please state also the nature of the
problem, conditions of use and purchase date.
If you require spare parts, always give the model,
serial number of your equipment and the spare
part number for the part you need. The spare part
list is at the back of this manual. Use only spare
parts mentioned in the spare part list.
Error codes
If the display shows an error code
(marked with "E"/ "DC" + number), restart the
equipment and check whether the display still
shows the error code. If the display still shows the
error code, immediately contact the dealer.

Transport and storage

⚠ WARNING
• Before cleaning and maintenance, remove
the mains plug from the wall socket.
• Carry and move the equipment with at least
two persons.
• Make sure that there are no other persons or
objects under the equipment.
• When folding the folding the equipment,
make sure that you hear the equipment lock
into position to prevent the equipment from
dropping back down.
- Move the equipment as shown (fig. F3). Move
the equipment and carefully put the equipment
down. Place the equipment on a protective base
to prevent damage to the floor surface. Move
the equipment carefully over uneven surfaces.
Do not move the equipment upstairs using
the wheels, but carry the equipment by the
handlebars.
- Store the equipment in the upright position (fig.
F1). Store the equipment in a dry place with as
little temperature variation as possible.

Additional information

Packaging disposal
Government guidelines ask that we reduce the
amount of waste material disposed of in land fill
sites. We therefore ask that you dispose of all
packaging waste responsibly at public recycling
centres.
End of life disposal
We at Tunturi hope you enjoy many years of
enjoyable use from your fitness trainer. However, a
time will come when your fitness trainer will come
to the end of its useful life. Under 'European WEEE
Legislation you are responsible for the appropriate
disposal of your fitness trainer to a recognised
public collection facility.
English
21