Herunterladen Inhalt Inhalt Diese Seite drucken

Troubleshooting; Error Codes; Oil; Code - Tunturi Cardio Fit T5 Benutzerhandbuch

Vorschau ausblenden Andere Handbücher für Cardio Fit T5:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 22
GB
REASON 3
The running belt is not centred correctly between the front and rear
roller drum� This needs be corrected by adjusting the running belt
tracking as described below�
To adjust the running belt's tracking use the Allen key being provided
with your treadmill�
- Set your treadmill at a speed of ± 5 km/h, not running on it�
- When the running belt is tracking to the right side�
Turn the left-hand rear roller adjustment bold, located on the rear
end in a socket in the rear roller cover, counter clockwise for 1/4
turn�
- When the running belt is tracking to the left side�
Turn the right-hand rear roller adjustment bold, located on the rear
end in a socket in the rear roller cover, counter clockwise for 1/4
turn�
- Await ±2 minutes to give the running belt the time to respond to
the adjustment before repeating the adjustment steps if needed to
get to the desired result�
‼ NOTE
• Remember, a small adjustment can make a big difference, so
make the adjustments with small steps at the time�
Click to see our supportive YouTube video
https://youtu�be/qx5AvTv00J4
The belt may require periodic tracking adjustment depending on use
and walking/running characteristics� Some users will affect tracking
differently� Expect to make adjustments as required to centre the
tread-belt� Adjustments will become less of a maintenance concern
as the belt is used� Proper belt tracking is an owner responsibility
common with all treadmills�
‼ NOTE
• Damage to the running belt because of incorrect running-belt
adjustments is not covered by the products warranty�

Troubleshooting

Despite continuous quality control, defects and malfunctions caused
by individual components may occur in the equipment� In most cases
it's unnecessary to take the whole device in for repair, as it's usually
sufficient to replace the defective part�
If the equipment does not function properly during use, contact your
Tunturi dealer immediately� Always give the model and serial number
of your equipment� Please state also the nature of the problem,
conditions of use and purchase date�
If you require spare parts, always give the model, serial number of
your equipment and the spare part number for the part you need�
The spare part list is at the back of this manual� Use only spare parts
mentioned in the spare part list�

Error codes

If the display shows an error code
(marked with "E" + number), restart the equipment and check
whether the display still shows the error code� If the display still shows
the error code, immediately contact the dealer�

Oil

OIL is not an error code, see "Lubrication"

Code "-- -- --"

Console will show "-- -- --" code when safety key is not in (correct)
position during start up�
"-- -- --" is not an error code, see "Safety key"

Transport and storage

⚠ WARNING
• Before cleaning and maintenance, remove the mains plug from
the wall socket�
• Carry and move the equipment with at least two persons�
• Make sure that there are no other persons or objects under the
equipment�
• When folding the folding the equipment, make sure that you
hear the equipment lock into position to prevent the equipment
from dropping back down�
⚠ CAUTION
• Before folding the equipment, make sure that the incline is 0%� If
the incline is not 0%, folding will damage the mechanism�
- Move the equipment as shown (fig� F3)� Move the equipment
and carefully put the equipment down� Place the equipment on
a protective base to prevent damage to the floor surface� Move
the equipment carefully over uneven surfaces� Do not move the
equipment upstairs using the wheels, but carry the equipment by
the handlebars�
- Store the equipment in the upright position (fig� F1)� Store the
equipment in a dry place with as little temperature variation as
possible�

Additional information

Packaging disposal
Government guidelines ask that we reduce the amount of waste
material disposed of in land fill sites� We therefore ask that you
dispose of all packaging waste responsibly at public recycling centres�
End of life disposal
We at Tunturi hope you enjoy many years of enjoyable use from your
fitness trainer� However, a time will come when your fitness trainer will
come to the end of its useful life� Under 'European WEEE Legislation
you are responsible for the appropriate disposal of your fitness trainer
to a recognised public collection facility�
2 0

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

21tcft0050

Inhaltsverzeichnis