DMX-Mode
The device has 2 DMX-modes. The Control Board allows you, as described above, to assign the DMX-Mode.
Addressing
Press the MODE-button until the display shows Addr. You can now set the desired address via the UP or
DOWN buttons. Press Enter to confirm. The Control Board allows you to assign the DMX fixture address,
which is defined as the first channel from which the LED IP PAR 36x1W RGB/LED IP PAR 12x3W TCL will
respond to the controller.
Please, be sure that you don't have any overlapping channels in order to control each LED IP PAR 36x1W
RGB/LED IP PAR 12x3W TCL correctly and independently from any other fixture on the DMX-chain.
If several LED IP PAR 36x1W RGB/LED IP PAR 12x3W TCL are addressed similarly, they will work
synchronically.
Controlling:
After having addressed the LED IP PAR 36x1W RGB/LED IP PAR 12x3W TCL, you may now start operating
it via your lighting controller.
Note:
It's necessary to insert the XLR termination plug with 120
proper transmission on the DMX data link.
DMX-Protocol
5 Channel Mode
Channel:
Value:
1
000 – 255
Channel:
Value:
2
000 – 255
Channel:
Value:
3
000 – 255
Channel:
Value:
4
000 – 255
Channel:
Value:
000 – 000
001 – 005
5
006 – 010
011 – 255
3 Channel Mode
Channel:
Value:
1
000 – 255
Channel:
Value:
2
000 – 255
Channel:
Value:
3
000 – 255
Function:
Red (0 – 100%)
Function:
Green (0 – 100%)
Function:
Blue (0 – 100%)
Function:
Dimmer (0 – 100%)
Function:
ON
No function
ON
Strobe (increasing)
Function:
Red (0 – 100%)
Function:
Green (0 – 100%)
Function:
Blue (0 – 100%)
22/23
in the last lighting in the link in order to ensure
00063704.DOC, Version 1.1