Dmx-512 Connection / Connection Between Fixtures - EuroLite 36x1W RGB Bedienungsanleitung

Procedure:
Step 1: The holes for the installation are on the mounting bracket.
Step 2: Hold the mounting bracket onto the location where the device is to be installed.
Step 3: Mark the boreholes with a pen or a suitable tool.
Step 4: Drill the holes.
Step 5: Hold the mounting bracket in the desired position and fix it.
Before taking into operation for the first time, the installation has to be approved by an expert!

DMX-512 connection / connection between fixtures

The wires must not come into contact with each other, otherwise
Please note, the starting address depends upon which controller is being used.
For the plug connection between controller and the device please use the enclosed adapter cable. For this
purpose, connect the DMX input plug of the device with the adapter cable. Fasten the locknuts on the
connectors. Then connect the 3-pin XLR-plugs of the adaper cable with the 3-pin XLR-connectors of the
controller.
To connect one fixture with another, connect the DMX output connector of the first fixture in the DMX chain
to the DMX input plug of the next fixture. Always connect one output with the input of the next fixture until all
fixtures are connected. If required, you can also use the 5 m extension cable (available accessory).
Occupation of the XLR-connection:
If you are using controllers with this occupation, you can connect the DMX-output of the controller directly
with the DMX-input of the first fixture in the DMX-chain. If you wish to connect DMX-controllers with other
XLR-outputs, you need to use adapter cables.
Building a serial DMX-chain:
Connect the DMX-output of the first fixture in the DMX-chain with the DMX-input of the next fixture. Always
connect one output with the input of the next fixture until all fixtures are connected.
Caution: At the last fixture, the DMX-cable has to be terminated with a terminator. Solder a 120
between Signal (–) and Signal (+) into a 3-pin XLR-plug and plug it in the DMX-output of the last fixture.
DANGER TO LIFE!
the fixtures will not work at all, or will not work properly.
19/23
resistor
00063704.DOC, Version 1.1