Instructions For The Installer; Electrical Connection - Electrolux EON 30620 Gebrauchsanleitung

Instructions for the Installer

The instructions given below are
designed specifically for a
qualified installer and should aid
him or her to perform all
installation, adjustment, and
maintenance operations with
absolute
compliance with all current
legislation and regulations. We
strongly recommend that all
operations for the installation of
your cooker be carryed out by
Qualified Personnel in accordance
with existing rules and regulations.

Electrical connection

Prior to making the electrical connection,
make sure that:
— the protection fuse and the domestic wiring
system are suitable to carry the total
electric load of the oven (see rating plate);
— your domestic wiring system has an
efficient earth connection in compliance
with rules and laws in force;
— the wall socket or the omnipole switch used
for the electrical connection can easily be
reached after the oven is built in.
This appliance is delivered without an electric
supply cable, therefore, you will have to fit to it
a supply cable with standard plug, suitable for
the total electric load shown on the rating plate.
The plug is to be inserted into a suitable wall
socket. If you require a direct connection to
the electric network (mains), it will be
necessary to fit between the appliance and
the mains an omnipole switch, with a minimum
gap between contacts of 3 mm, suitable for
the required load and in compliance with rules
in force. The green & yellow ground wire must
not be interrupted by the switch, and should
be 2-3 cm longer than the phase and neutral
wires. The supply cable must in all cases be
laid out in such a way as to ensure that it
52 electrolux
Downloaded from www.Manualslib.com
precision and
manuals search engine
in