Safety Instructions - Electrolux EB6L80SP Benutzerinformation

Disconnect the appliance from the power supply before
•
carrying out any maintenance.
If the mains power supply cable is damaged, it must be
•
replaced by the manufacturer, its Authorised Service Centre
or similarly qualified persons to avoid an electrical hazard.
The means for disconnection must be incorporated in the
•
fixed wiring in accordance with the wiring rules.
WARNING: Ensure that the appliance is switched off before
•
replacing the lamp to avoid the possibility of electric shock.
WARNING: The appliance and its accessible parts become
•
hot during use. Care should be taken to avoid touching
heating elements.
Always use oven gloves to remove or put in accessories or
•
ovenware.
To remove the shelf supports first pull the front of the shelf
•
support and then the rear end away from the side walls.
Install the shelf supports in the opposite sequence.
Do not use a steam cleaner to clean the appliance.
•
Do not use harsh abrasive cleaners or sharp metal scrapers
•
to clean the glass door since they can scratch the surface,
which may result in shattering of the glass.
Excessive spillage must be removed before the pyrolytic
•
cleaning. Remove all parts from the oven.

2. SAFETY INSTRUCTIONS

2.1 Installation
WARNING!
Only a qualified person must
install this appliance.
• Remove all the packaging.
• Do not install or use a damaged
appliance.
• Follow the installation instructions
supplied with the appliance.
• Always take care when moving the
appliance as it is heavy. Always use
safety gloves and enclosed footwear.
• Do not pull the appliance by the handle.
4 ENGLISH
• Install the appliance in a safe and suitable
place that meets installation requirements.
• Keep the minimum distance from other
appliances and units.
• Before mounting the appliance, check if
the oven door opens without restraint.
• The built-in unit must meet the stability
requirements of DIN 68930.
Cabinet minimum height
(Cabinet under the worktop
minimum height)
Cabinet width
Cabinet depth
590 (600) mm
560 mm
550 (550) mm