Electrolux EON 30620 Gebrauchsanleitung Seite 47

6) place the door on a stable surface (Fig. 12)
protected by a soft cloth to prevent the
handle surface from being damaged;
7) release the locking system to remove the
internal panes of glass (Fig. 13);
8) turn the 2 fasteners 90° and extract them
from their seats (Fig. 14);
9) gently lift and carefully take off the upper-
most pane marked by a decorative frame
on 4 sides (Fig. 15).
Clean the oven door with lukewarm water
and a soft cloth. Do not use products such as
scouring pads, steel wool, abrasive sponges
or acids because they could damage the
special heat-reflecting surface of the internal
panes of glass.
After cleaning, reassemble the panes in the
door and then the oven door, following the
procedure described above in reverse. Make
sure you reposition the panes correctly.
To perform this operation correctly, proceed
as follows:
- the decorated internal pane with a frame on
the 4 sides must be reassembled so that the
screen-printing is facing outwards. The side
of the pane of glass is correct if you do not feel
any roughness near the screen printing when
you pass your fingers over the surface.
Downloaded from www.Manualslib.com manuals search engine
Fig. 12
Fig. 13
90°
Fig. 14
electrolux 47