Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Placing the unit
1
Remove all packing materials from the shipping box. Make sure that there are no packing remnants at the fog
output nozzles.
2
Make sure that the scope of delivery is complete and that the device is not damaged.
3
Place the machine on a level surface and fix the castors with the brakes.
4
Loosen the butterfly locks and remove the lid.
5
Fasten the fog hoses to the outlet nozzles of the machine using the quick connectors. Position the end of the
hoses in the hose guides.
Notes
• Do not place the device where there is a slope or incline.
• Install the device in a well-ventilated area. The operation in an insufficiently ventilated room can lead to a
condensation of the fog fluid. The resulting slippery surface can cause accidents.
• The operation of the device can lead to an increase in room humidity and thus possibly damage devices that are
sensitive to high humidity.
• Keep a minimum distance of 20 cm around and above the device.
• Do not orientate the output nozzle directly in the direction of the audience's eyes. In order to create a good
effect, there should be a distance between the device and the audience of at least 1.5 m.
• All fog machines develop condensation around the output nozzle. Because this may result in some moisture
accumulation on the surface below the output nozzle, consider this condensation when installing your unit.
Filling up water and fog fluid
Fluid handling
Always disconnect from the mains before filling the machine. Only use water-based fluids. We
recommend high-quality Eurolite fluids. Never add flammable liquids. If fluid gets inside the machine,
have it checked by skilled personnel before it is operated.
1
Fill the large water tank no. 1 with distilled water. The water tank capacity is 18 liters. Please fill only distilled
water and no other substances into this tank. The water quantity can be checked visually with the filling level
indicator on the side during operation. It is not necessary to fill the small water tank no. 2, because the water is
automatically pumped from tank 1 into this tank.
2
Fill fog fluid into the fluid tank. The best effect is achieved with the Eurolite fluid listed in the accessories
section. To avoid contamination of the fog liquid, you should always replace the cap on the liquid container
immediately after filling. Make sure that there is always sufficient fluid in the tank.
3
Make sure that the inlet hoses are securely attached and not kinked.
Switching on
Operating conditions
Operation with empty water and fluid containers can lead to overheating and permanent damage of the
pump. When operating, always ensure that there is sufficient fog fluid and water in the liquid containers
to avoid no-load running.
1
Connect the device to the mains and switch it on. The machine starts to heat up and the display shows
"Warming up".
2
Activate the pump by briefly pressing the WATER PUMP button (button illuminates). The pumping process is
started and a humming sound is heard. The pumping process is automatically controlled and completed after
about 3 minutes.
3
The heat-up process also takes about 3 minutes. As soon as it is finished, the display shows "Ready To Fog".
After that the machine is ready to emit fog.
Note: Additionally, a "W" for wireless and an "S" for fluid sensor is indicated if these functions are activated.
4
Make the necessary menu settings with the buttons on the control panel or press and hold the MANUAL
button to activate the fog output immediately.
SETUP
WARNING!
CAUTION!
20 • EN
Werbung
Kapitel
Inhaltsverzeichnis
