5
SETUP
1
Remove all packing materials from the shipping box. Make sure that there are no packing remnants at
the fog output nozzle.
2
Unscrew the tank cap and fill the tank with fog fluid. Tightly close the tank again.
The fluid tank needs to be filled with fog fluid before starting operation and always disconnected from
the mains as fluid could be spilled.
Only use quality fog fluids available at your dealer. We recommend high-quality EUROLITE fog fluids.
You must not use substances that are classified as "dangerous working material" or "inflammable
fluids".
3
Connect the included remote control to the jack REMOTE CONTROL.
4
Connect the device to the mains with the power plug.
Adjusting the Output Angle
The output angle can be adjusted by raising the device via the two supporting legs. The legs can be raised
up to five steps.
Installation
Place the machine on a plane surface or mount it via its bracket.
• Install the device in a well-ventilated area. The operation in an insufficiently ventilated room can lead to a
condensation of the fog fluid. The resulting slippery surface can cause accidents.
• Keep a minimum distance of 20 cm around and above the device.
• Furthermore, do not orientate the escape nozzle directly in the direction of the audience's eyes. In order to
create a good effect, there should be a distance between the device and the audience of at least 1.5 m.
• Only install the fog machine on scratch resistant and water resistant surfaces.
• Please make sure that the inclination angle does not exceed 15°.
www.eurolite.de
23