Setup; Filling Up Fog Fluid; Placing The Unit; Operation - EuroLite NSF-100 Bedienungsanleitung

Filling up fog fluid

Fluid handling
Always disconnect from the mains before filling the machine. Only use water-based fluids. We
recommend high-quality Eurolite fluids. Never add flammable liquids. If fluid gets inside the machine,
have it checked by skilled personnel before it is operated.
Unscrew the tank cap and fill the tank with fog fluid. Tightly close the tank again.

Placing the unit

• Remove all packing materials from the shipping box. Make sure that there are no packing remnants at the fog
output nozzle.
• Install the device in a well-ventilated area. The operation in an insufficiently ventilated room can lead to a
condensation of the fog fluid. The resulting slippery surface can cause accidents.
• Keep a minimum distance of 20 cm around and above the device.
• Only install the fog machine on scratch resistant and water resistant surfaces (inclination angle max. 15°).
• Do not orientate the escape nozzle directly in the direction of the audience's eyes. In order to create a good
effect, there should be a distance between the device and the audience of at least 1.5 m.
• All fog machines develop condensation around the output nozzle. Because this may result in some moisture
accumulation on the surface below the output nozzle, consider this condensation when installing your unit.
Operating conditions
Prior to transportation, allow the machine to cool down and completely empty the tank.
Never operate the fog machine without fog fluid. Fire hazard due to overheating! Besides, the unit may
be damaged.
During operation smoke emission may stop. In this case the device is heating up again. After a short
period, the machine will be ready to emit fog again. This process guarantees an appropriate
vaporization temperature and the best fog emission possible. The temperature is regulated by a high-
quality thermostat.
The built-in control panel on the rear of the machine features four operating buttons and a display which shows all
operation statuses of the machine. The control panel allows the user to customize the color of the LEDs, the DMX
starting address, the fluid sensor and wireless remote control. The machine can be operated manually with the
button at the control panel or the remote control. Alternatively, it can be controlled with a DMX controller. DMX
control will take priority over the manual operation.

Switching on/off

• Prior to switching on, check the fluid level of the tank and fill up fog fluid, if required.
• Connect the machine to the mains with the power plug.
• Switch on the machine with the power switch (lights up). The machine will heat up for approx. 3 minutes and
"HEAT" is indicated in the display.
• While the machine is warming up, fog output will not be possible yet. Once the warm-up process is completed,
the display indicates the standard screen and fog output will be possible.
• After operation, switch off the machine with the power switch.

SETUP

WARNING!

OPERATION

CAUTION!
19 • EN