Explosion And Fire Hazard - AEG 10616 Bedienungsanleitung

22 www.aeg-automotive.com
Explosion and fire
hazard!
• Gaseous hydrogen (detonating
gas) may form when charging the
battery. Contact with open fire
(flame, embers, sparks) may result
in explosions.
• Never charge the battery close to an
open fire or in places where sparks
may occur.
• Always ensure adequate ventilation.
• Be sure the supply voltage matches
the input voltage specified on the
device (230 V AC) to prevent dama-
ge to the device.
• Only connect and disconnect the
battery connecting cables when the
charger is disconnected from the
mains.
• Do not cover the device whilst char-
ging, as it may be damaged from
extreme heating.
• Immediately stop using the device
if you notice smoke or an unusual
odour.
• Do not use the device in rooms
where explosive or flammable
substances are stored (e.g. petrol or
solvents).
Risk of electrical shock!
• Chargers may interfere with the
operation of active electronic im-
plants, e.g. pacemakers, thus pose a
personal hazard.
• Avoid pouring or dripping water or
other liquids over it. If water pene-
trates electrical devices, the risk of
electric shock increases.
• Ensure that all plugs and cables
are free of moisture. Never connect
the device to the mains with wet or
moist hands.
• Never touch both connections at
once when the device is in uses.
• unplug from mains before connec-
ting or disconnecting the charging
cable with the battery, or when the
device is no longer being used.
• Remove all device cables from the
battery before attempting to drive
your vehicle.
• Always unplug device by the plug.
The cable may be damaged.
• Do not use device if damaged. Da-
mage to the power cable, the device
or the charging cable increase the
risk of electrical shock.
• Do not attempt to disassemble or
repair the device. Immediately have
a defective device or damaged
power cable repaired or replaced by
a speciality shop.