Operation; Panel Button Functions; Lcd Panel - V7 UPS2URM1500DC-NC Bedienungsanleitung

3. Operation

3-1. Panel Button Functions

Button Function
 Turn on the UPS: Press and hold ON/Mute button for at least 2 seconds to
 Mute the alarm: After the UPS is turned on in battery mode, press and
ON/Mute
Button
 Up key: Press this button to display previous selection in UPS setting
 Switch to UPS self-test mode: Press ON/Mute buttons for 3 seconds to
 Turn off the UPS: Press and hold this button at least 2 seconds to turn off
OFF/Enter
Button
 Confirm selection key: Press this button to confirm selection in UPS
 Switch LCD message: Press this button to change the LCD message for
Select
Button  Settings mode: Press and hold this button for 3 seconds to enter UPS
 Down key: Press this button to display next selection in UPS setting
 Switch to bypass mode: Under normal main power, press ON/Mute and
ON/Mute
+ Select
 Exit settings mode or return to the upper menu: When working in settings
Button

3-2. LCD Panel

turn on the UPS.
hold this button for at least 3 seconds to disable or enable the alarm
system. This mute will not apply to the occurrence of UPS warnings or
errors.
mode.
enter UPS self-testing while in AC mode, ECO mode, or converter mode.
the UPS. The UPS will be in standby mode under normal power or
transfer to Bypass mode if the Bypass setting is enabled by pressing this
button.
setting mode.
input voltage, input frequency, input current, battery voltage, battery
current, battery capacity, ambient temperature, output voltage, output
frequency, load current and load percent.
settings mode in Standby and Bypass modes.
mode.
Select buttons simultaneously for 3 seconds. Then UPS will enter to
bypass mode. NOTE: This action will be ineffective when input voltage is
out of an acceptable range.
mode, press ON/Mute and Select buttons simultaneously for 0.2 seconds
to return to the upper menu. Once the top menu is reached, press these
two buttons at the same time to exit the settings mode.
10