Herunterladen Inhalt Inhalt Diese Seite drucken

Fluval Roma Gebrauchsanleitung Seite 5

Led-strip-light und aquarium
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Carefully examine the appliance after installation. It should not be plugged in if there is water on parts
not intended to be wet.
Do not operate any appliance if it has a damaged cord or plug, or if it is malfunctioning or if it is
dropped or damaged in any manner. The power cord of this appliance cannot be replaced; if the cord
is damaged, the appliance should be discarded. Never cut the cord.
To avoid the possibility of the appliance plug or wall socket getting wet, position the
unit to one side of a wall mounted wall socket to prevent water from dripping onto
the socket or plug. A "drip loop" (see illustration) should be arranged to the socket.
The "drip loop" is that part of the cord below the level of the socket (or the connector
if an extension cord is used), to prevent water travelling along the cord and coming
into contact with the wall socket. If the plug or socket does get wet, DON'T unplug
the cord. Disconnect the fuse or circuit breaker that supplies power to the appliance.
Then unplug and examine for presence of water in the wall socket.
3. Close supervision is necessary when any appliance is used by or near children. This appliance can be used
by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities
or lack of experience and knowledge if they have been given supervision or instruction concerning use of
the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance.
Cleaning and user maintenance shall not be made by children without supervision. This product is not a toy.
4. To avoid injury, do not come into contact with moving parts or hot parts such as heaters, LED device, etc.
5. CAUTION – Always unplug or disconnect all appliances in the aquarium from electricity supply before
placing hands in water, before putting on or taking off parts and whilst this LED Strip Light is being installed,
maintained or handled. Never yank cord to pull plug from outlet. Grasp the plug and pull to disconnect.
Always unplug an appliance from an outlet when not in use.
WARNING: Be sure you unplug the LED driver from the power outlet; just switching off the
lights with the APP is NOT enough because it does not stop the power supply.
Do not use an appliance for other than intended use (i.e. don't use on swimming pools, garden ponds,
bathrooms, etc.). The use of attachments not recommended or sold by the appliance manufacturer may
result in a dangerous situation. Do not try to repair any product component: in case of damage replace
the damaged component with original spare parts.
6. IMPORTANT: This LED Strip Light is a non-submersible AQUARIUM LUMINAIRE suitable FOR INDOOR
USE ONLY designed to be assembled onto FLUVAL Roma, Vicenza and Venezia Top Cover Frames only.
For fresh and salt water ornamental aquariums with max 35 °C water temperature. Do not install or store the
appliance anywhere where temperatures may drop below freezing.
7. IMPORTANT: Make sure that the LED Strip Light is securely and correctly installed before operating it and
that the minimum distance of water from the LED Strip Light is 15 mm. This LED Strip Light must never
operate in water.
Fill the aquarium up to level indicated on the label situated on the
inside of the aquarium's top frame. IMPORTANT: Do not over fill.
Overfilling the aquarium can cause water to pass under the
top frame which then runs down the outside of the aquarium.
WARNING: Do not plug in the LED Strip Light if there is
water on parts not intended to be wet.
WARNING: Do not place any object(s) on the LED Strip Light (C) or on the Canopy (B). Ensure sufficient
air space around the LED Strip Light. The safety of this appliance is only ensured provided that it has
been properly installed.
8. Read and observe all the important notices on the appliance.
9. If an extension cord is necessary, a cord with a proper rating should be used. A cord rated for less amperes
or watts than the appliance rating may overheat. Care should be taken to arrange the cord so that it will not
be tripped over or pulled.
10. SAVE THESE INSTRUCTIONS
max water level - maximum niveau de
l'eau - maximales Wasserniveau - nivel
del agua máximo - nível de água máximo
massimo livello dell'acqua
DRIP LOOP
5

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

VicenzaVenezia

Inhaltsverzeichnis