External/Internal Fluval Filter Installation, Use And Maintenance; Fluval Heater Installation And Preparation, Use And Maintenance; Led Strip Light Installation Instructions; Features And Tips - Fluval Roma Gebrauchsanleitung

EXTERNAL/INTERNAL FLUVAL FILTER INSTALLATION,
USE AND MAINTENANCE
Please refer to the instruction manual of the Fluval filter. Do not attempt to set up the Fluval filter without reading and
following the instruction manual. If it is missing or unusable, contact the store or Hagen Customer Service.
FLUVAL HEATER INSTALLATION AND PREPARATION,
USE AND MAINTENANCE
Please refer to the instruction manual of the Fluval heater. Do not attempt to set up the Fluval heater without
reading and following the instruction manual. If it is missing or unusable, contact the store or Hagen Customer
Service.

LED STRIP LIGHT INSTALLATION INSTRUCTIONS

WARNING: Disconnect the plug of all electrical equipment used for the aquarium, before placing your
hands in aquarium water and/or performing any maintenance of any kind.

Features and tips

Access Lids
The canopies are equipped with 2 Access Lids (3 for Venezia 350). This allows easy access to your aquarium.
Optional Extra for Roma Aquariums: Opening for the Fluval PF2 Automatic feeder
A replacement canopy rear lid is available including an opening for the use of a Fluval PF2 Automatic feeder.
Pull to remove the plastic plug and access the compartment. To close, press the plastic plug in its place. (Visit
the replacement parts section on

Initial start-up

1. Carefully place the LED Strip Light (C) on the runner of the top frame in the final position (Pict. 8)
2. Hook up the lighting unit to the LED driver with its connector. Pict. 9 also shows the connection of 2 lighting units on a
Venezia 350. Only use the supplied drivers for these light units.
3. Place the aluminium beam (B2) and the front and rear access lids (B1) on the aquarium top frame (Pict. 10). Venezia
350 features 2 aluminium beams and 3 access lids. Ensure that the electrical cord and plug does not get wet.
WARNING: Do not plug in the LED Strip Light if there is water on parts not intended to be wet.
Pict. 8
Switching the LED Strip Light On
Plug in the unit and use a smartphone or tablet with the Fluvalsmart app
downloaded to connect to it. Use exclusively the LED driver supplied with
the LED Strip Light. In all cases make sure that LED driver specifications
conform to LED driver specs indicated in the Roma, Vicenza and Venezia
LED Strip Light identification codes tables below.
Maintenance:
For maximum LED performance, it is recommended that the fixture and
the LED lens be cleaned on a weekly basis. Unplug the LED driver prior
to cleaning the light fixture. Use both hands when manipulating this appliance. Wipe exposed surfaces carefully with a
damp cloth to remove any dust or mineral deposits that may collect over time. Do not use detergents or harsh cleaners
as it can damage the light fixture. Use Fluval LED Lens Cleaning Non-Aerosol Spray (A3969) to clean the LED portion
of the light fixture. Make sure all surfaces are dry before re-connecting the LED driver to the power source
10
www.fluvalaquatics.com for order codes).
Pict. 9
For full instruction manual and video on set up of
Bluetooth® application, visit:
fluvalaquatics.com/aquaskybluetooth
Fig. 10
SCAN HERE to learn more and
download the free Fluval Smart
app or search 'Fluvalsmart' in
app store.
.