Grundfos Conex DIA-1 Montage- Und Betriebsanleitung Seite 37

11.6.5 Controller control fields on the display
chlorine
0.43
mg/l
5.20 pH
22 °C
1 2
Fig. 32 Chlorine measurement with pH and
temperature compensation
1. Press [Esc] once or twice to switch to the display
"measured value".
See sections 11.2 Display elements during initial
commissioning and 11.5.2 pH and temperature
compensation.
The control fields shown on the display "measured
value" correspond to the configured controller.
• The control field ">" will only be displayed if an
external setpoint has been defined. Depending
on the selected standard range (0-20 mA or 4-20
mA) and the defined setpoint level, it is displayed
as not filled, partly filled or completely filled
(displayed inversely).
Not filled (at 0 or 4 mA):
Partly filled, for example setpoint 4 mA
(standard range 0-20 mA):
Completely filled, for example setpoint 20 mA
(standard range 0(4) to 20 mA):
1 2
c
c
continuous
controller
relay 2
relay 1
external setpoint
• The control fields for relays 1 and 2 are displayed
if a limit contact / two-position controller has been
configured:
Unfilled field for relay off:
1
Filled field (displayed inversely) for relay on:
1
• The control field for the continuous controller is
displayed if a continuous controller has been
configured. Depending on the set dosing flow, it
is displayed as empty or as filled by a black bar
that indicates the current dosing flow in relation
to the system's maximum dosing flow.
Example:
0 %:
50 %:
100 %:
37