IARP EXCITE Gebrauchs- Und Bedienungs Anleitungen Seite 26

10.2 INNER CLEANING
WARNING! TURN OFF POWER SUPPLY TO THE CABINET BY DISCONNECTING THE POWER PLUG BEFORE
CLEANING.
To always achieve the highest performance we recommend a manual defrosting when the frost layer on the tank
walls exceeds 5 mm thickness. For tank cleaning proceed as follows:
1. Place the goods in special refrigerated containers, kept at the same temperature and remove the shelves
2. Unplug the unit
3. Leave the doors open and begin the operation of tank washing when the tank temperature is the same as the
ambient temperature.
4. Clean and dry the interior of the tank with a soft cloth, using neutral soap.
5. Then plug the unit and wait till the appliance reaches the right temperature before filling it again.
Do not use any aggressive or abrasive cleaning agents.
Never use a water hose or a high-pressure jet to clean the cabinet.
Do not use jet of water to clean the cabinet: electrical wiring could be damaged.
Never use mechanical devices or any other means to accelerate the defrosting
process, other than those recommended by the manufacturer.
11. TEMPERATURE SETTING AND CONTROLS
Each refrigerating appliance is provided with an electronic control for automatic maintenance of the appropriate pre-
established temperature inside the tank.
This temperature adjuster is gauged by the factory and should not be touched by the user.
Only if the average internal temperature is too cold or not cold you can increment or decrement the temperature:
1. Press the (▲ or ▼)
2. Press the (▲) key or the (▼) key in order to increment or decrement the temperature set point.
LIGHT SWITCH
key in order to see on display the temperature set point.
-26-