17.1 Cleaning, Maintenance, Storge, Disposal; Cleaning; Maintenance; Maintenance Schedule - HOLZMANN-MASCHINEN KAM215EPSV Betriebsanleitung

17 CLEANING, MAINTENANCE, STORGE, DISPOSAL

17.1 Cleaning

Wrong cleaning agents can attack the varnish of the machine. Do not use solvents,
nitro thinners, or other cleaning agents that could damage the machine's paint.
Observe the information and instructions of the cleaning agent manufacturer!
Regular cleaning is a prerequisite for the safe operation of the machine and its long service life.
 Therefore, clean the machine after each use and remove any sawdust with a brush, broom
or vacuum cleaner.

17.2 Maintenance

Handling the machine with the power supply and compressed air supply up can lead
to serious injuries or even death. Always disconnect the machine from the power and
compressed air supply before servicing or maintenance work and secure it against
unintentional or unauthorised reconnection!
The machine is low-maintenance and only a few parts have to be serviced. Nevertheless,
malfunctions or defects which could impair the safety of the user must be rectified immediately!
 Before each operation, check that the safety devices are in perfect condition.
 Check the connections for tightness at least once a week.
 Regularly check that the warning and safety labels on the machine are in perfect and
legible condition.
 Only use original spare parts recommended by the manufacturer
17.2.1

Maintenance schedule

The type and degree of machine wear depend on the operating conditions. The following intervals
apply when the machine is used within the specified limits:
interval
Before usage machine
Before usage machine
After 2 weeks Conveyour belt
Not-Halt-
1x month
Befehlseinrichtung
as required Tool change
17.2.2

Cutter change (pre-milling unit)

Milling tools have sharp edges. Use cut-resistant gloves to prevent injuries.
HOLZMANN MASCHINEN GmbH
NOTE
WARNING
components
CAUTION
www.holzmann-maschinen.at
CLEANING, MAINTENANCE, STORGE, DISPOSAL
activity
Cleaning the machine
Removal of all loose parts / tools
Check milling tool / saw blade for damage and re-
place when necessary
Greasing / Lubricating the grease nipple
Checking the emergency stop function by means of
a function test
Change (wear, damage)
51
KAM215EPSV