Other Error-Messages - HOLZMANN-MASCHINEN KAM215EPSV Betriebsanleitung

tablish the closing contact completely)
16.4.5

Other error-messages

Check the edge band saw unit in the respective error categories displayed.
 Fault in the position switch for edge trimming
 Faults in the magnetic switch for the front edge section
 Faults in the magnetic switch for the rear edge section
Parameter settings on the display:
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
The following times and settings can be made
on the display, whereby parameters 3-10 do
not need to be changed.
1: Parameter preset to 40 (time setting for
feeding)
2: Parameter preset to 13 (time setting for
feeding delay time)
3: Set parameter to 6 ( setting for inverter )
4: Set parameter to 300 (feed setting)
5: Set parameter to 40 (setting time delay for
pre-milling cutter 1)
6:Set parameter to 150 ( setting working time
of pre-milling cutter 1)
7: Set parameter to 80
8: Set parameter to 50 ( Setting
9:Set parameter to 15 (blowing delay time =
setting delay time before starting blowing)
10:Set parameter to 35 (stop blowing delay
time = setting delay time for stop blowing af-
ter switch is deactivated)
OPERATION
50
KAM215EPSV