Setting Double Trimming Unit; Setting Flat Scraper; Setting Polishing Unit - HOLZMANN-MASCHINEN KAM215EPSV Betriebsanleitung

16.1.8

Setting double trimming unit

16.1.9

Setting flat scraper

16.1.10 Setting polishing unit

HOLZMANN MASCHINEN GmbH
The polishing unit with the polishing wheels is used to re-
move and polish the remaining glue and the edge trims.
The directions of rotation of the polishing wheels are coun-
terclockwise at the top and clockwise at the bottom.
The polishing wheels should be embedded on the edge of
the workpiece about 3 ~ 5 mm.
This adjustment (vertical displacement) is made by loosen-
ing the clamping screws and the adjustment knobs on the
polishing unit.
www.holzmann-maschinen.at
The trimming unit has two setting options. The
cutters can be adjusted both horizontally and
vertically.
With the adjusting screws C the size of the
radius can be changed (horizontal).
The cutter can be adjusted horizontally with
"+" in front and with "-" back.
Vertically, the tool is adjusted with the A and
B knobs. This should always be done when
replacing the cutters.
Note: When adjusting the vertical position A
and B, the adjustment of the horizontal posi-
tion must be the same on both units. The
maximum edge band overhang on the work-
piece should be 2 mm.
The height of the upper and lower units can be
adjusted with the adjusting screw 1 by loosening
the lock nut.
The distance between the steel disc and the flat
scraper should be approximately 1 - 1.5 mm.
OPERATION
44
KAM215EPSV