Special Safety Instructions For That Machine; Hazard Warnings - HOLZMANN-MASCHINEN KAM215EPSV Betriebsanleitung

 A damaged or tangled cable increases the risk of electric shock. Handle the cable with
care. Never use the cable to carry, pull or disconnect the power tool. Keep the cable away
from heat, oil, sharp edges or moving parts.
 Proper plugs and sockets reduce the risk of electric shock.
 Water entry into machine increases the risk of electric shock. Do not expose machine to
rain or moisture.
 The machine may only be used in humid environments if the power source is protected by
a residual current circuit breaker.

12.6 Special Safety Instructions for that machine

 Work with gloves on rotating parts is not permitted!
 During operation of the machine wood dust is generated. Therefore, connect the machine
to a suitable dust collection system for dust and chips during installation!
 Always switch on the dust collection system before you start machining the workpiece!
 Never remove sections or other parts of the workpiece from the cutting area while the ma-
chine is running.
 When using milling tools with a diameter of ≥ 16 mm and circular saw blades, these must
comply with EN 847-1:2013 and EN 847-2:2013; tool carriers must comply with EN 847-
3:2013;
 Excessive noise can cause hearing damage and temporary or permanent hearing loss.
Wear hearing protection certified to health and safety regulations to limit noise exposure.
 Make sure that the machine is working without vibrations.
 Replace cracked and deformed saw blades immediately, they cannot be repaired.
 Glue and gluing unit are heated during operation, avoid any contact with hot compo-
nents/glue and wait for cooling phases before maintenance work.

12.7 Hazard Warnings

Despite their intended use, certain residual risks remain. Due to the structure and construction of
the machine, hazardous situations may occur when handling the machines:
A safety instruction designed in this way indicates an imminently hazardous situation
which, if not avoided, will result in death or serious injury.
Such a safety instruction indicates a potentially hazardous situation which, if not
avoided, may result in serious injury or even death..
A safety instruction designed in this way indicates a potentially hazardous situation
which, if not avoided, may result in minor or moderate injury.
A safety notice designed in this way indicates a potentially hazardous situation which,
if not avoided, may result in property damage.
Irrespective of all safety regulations, their sound common sense and corresponding technical
suitability/training are and remain the most important safety factor in the error-free operation of
the machine. Safe working depends first and foremost on you!
HOLZMANN MASCHINEN GmbH
DANGER
WARNING
CAUTION
NOTICE
www.holzmann-maschinen.at
SAFETY
37
KAM215EPSV