LIVARNO LUX HG06280 Bedienungs- Und Sicherheitshinweise Seite 27

adaptor . Otherwise there is
4
the risk of overloading the com-
ponents and fire. Simply connect
the head of secondary light strip
to the tail of first light strips.
Note: Ensure when connecting
the ends of the LED strip
you align the +GRB markings on
the ends of the strips with each
other.
Shorten the LED strip
(see Fig. B):
You are able to individually shorten
the LED strip . It can be cut with
3
scissors at the marked position,
as shown in Fig. B. The cut pieces
can be connected together as
shown in the diagram.
Connect as described below:
Remove the protective foil from
the double-sided adhesive tape
(on the back of LED strip)
at the ends of the component
pieces of the LED strip
ing connected.
Firmly press the end of one LED
strip onto the contact spikes
3
of the connection cable
so that this pierces the strip
conductor of the LED strip
from below (use suitable aid
would be good because the
process requires relative
force).
Note: Ensure that you align
the +GRB markings on the
that connection cable
3
+GRB marking of LED strip
Press a plastic clip
newly-made connection from
above.
Note: The plastic clips
must engage to secure the
connection.
Proceed in the same manner
for forming a contact on the
other end of the connection
cable
Note: The connection cable
tion, unlike the LED strip
contains sensitive solder joints.
10
Do not lead the LED strip
be- around corners or kink. This
3
could lead to damage of the
solder joints and malfunction
of the LED strip
2
3
.
2
can move in every direc-
2
The product
3
with the
2
.
3
onto the
1
1
.
3
3
.
GB/IE 27