Cleaning, Maintenance And Ordering Of Spare Parts; Disposal And Recycling - EINHELL TE-TS 36/210 Li-Solo Originalbetriebsanleitung

9. Cleaning, maintenance and
ordering of spare parts
Danger!
Always pull out the battery pack before starting
any cleaning work.
Take out the rechargeable battery each time be-
fore carrying out any adjustments, maintenance
or repairs.
9.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could at-
tack the plastic parts of the equipment. Ensu-
re that no water can seep into the device. The
ingress of water into an electric tool increases
the risk of an electric shock.
•
Regularly clean the dust collector (37). To do
so, undo the recessed head screw (17) and
pull the dust collector (37) out at the back of
the machine (Fig. 26). Carefully clean the dust
collector (37) and fit it securely back on the
circular saw in reverse order.
9.2 Carbon brushes
In case of excessive sparking, have the carbon
brushes checked only by a quali ed electrician.
Danger! The carbon brushes should not be rep
laced by anyone but a quali ed electrician.
9.3 Maintenance
There are no parts inside the equipment which
require additional maintenance.
Anl_TE_TS 36_210_Li_Solo_SPK9.indb 34 Anl_TE_TS 36_210_Li_Solo_SPK9.indb 34
GB
9.4 Ordering spare parts and accessories
Please provide the following information when
ordering spare parts:
•
Type of unit
•
Article number of the unit
•
ID number of the unit
•
Spare part number of the required spare part
For our latest prices and information please go to
www.isc-gmbh.info
Tip! For good results we
recommend high-quality ac-
cessories from
www.kwb.eu
welcome@kwb.eu
9.5 Transport
Only ever transport the machine by lifting it by the
saw table. Never use the safety devices such as
the saw blade guard and stop rails for handling or
transporting purposes.

10. Disposal and recycling

The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council o ces.
11. Storage
Pull out the battery pack.
Store the equipment and accessories in a dark
and dry place at above freezing temperature.
The ideal storage temperature is between 5 and
30 °C. Store the electric tool in its original pa-
ckaging.
- 34 -
!
19.03.2020 13:23:44 19.03.2020 13:23:44