Select The Input Source To Be Projected - JVC DLA-G150CLE Bedienungsanleitung

I Projector's buttons
STAND BY
LAMP TEMP
OPERATE
HIDE
PC
KEYSTONE
VIDEO
PRESET MENU
EXIT ENTER
I Remote control unit
QUICK
ALIGN. OPERATE
HIDE
W W
SCREEN SCREEN FREEZE COMP
VIDEO
S S
PC1 PC2 DVI Y/C
T T
DIGITAL
ZOOM FOCUS
KEYSTONE
ZOOM
W W
PRESET MENU
EXIT ENTER
RM-M160 REMOTE CONTROL UNIT
I Language display
The display languages of the menus, direct buttons
(DIGITAL ZOOM, KEYSTONE, etc) and messages is set to
"ENGLISH" when the projector is bought. The display
language can be selected from the following 6 languages:
" (Japanese)", "English (English)", "Deutsch
(German)", "Español (Spanish)", "Italiano (Italian)" and
"Français (French)". (Refer to page 46.) However, some
words (VIDEO, NTSC, Quick Alignment, etc) are only
displayed in English.
PC button
VIDEO button
PC button
VIDEO button
ZOOM button

2. Select the Input source to be Projected

Press the VIDEO button or the PC button to switch the input.
• Each time you press either button, the selected input
changes as follows. The selected name appears on the top
right of the image on the screen for five seconds. (Called
line display.)
When selecting an image device connected to the
AV IN (VIDEO, Y/C or COMP) terminal:
Projector
Press VIDEO.
The input mode changes as follows every time the button is
pressed.
VIDEO ↔ Y/C ↔ COMP
Remote control unit
Press the "VIDEO", "Y/C" or "COMP" button.
VIDEO: The image from the VIDEO input terminal on the
side of the unit is projected.
Y/C: The image from the Y/C input terminal on the side of
the unit is projected.
COMP: The image from the COMP (Y, R
input terminal on the side of the unit is projected.
* When there is no signal from the selected input terminal
(No signal), "No Input" is displayed.
When selecting a device such as a computer
which is connected to the PC1, PC2 or DVI
terminal:
Projector
Press PC.
The input mode changes as follows every time the button is
pressed.
PC1 ↔ PC2 ↔ DVI
Remote control unit
Press the "PC1", "PC2" or "DVI" button.
PC1: The image from the PC1 input terminal on the side of
the unit is projected.
PC2: The image from the PC2 input terminal on the side of
the unit is projected.
DVI: The image from the DVI input terminal on the side of
the unit is projected.
* When there is no signal from the selected input terminal
(No signal), "No Input" is displayed.
Remote control unit
SCREEN SCREEN FREEZE COMP VIDEO
S S
PC1 PC2 DVI Y/C
[Screen display]
VIDEO
Q U I C K A L I G N M E N T
* To show the line display (Y/C, VIDEO, COMP, PC1, PC2 or
DVI) or not is selectable by the menu. Refer to "Setting and
Adjusting Other Functions (OPTIONS)" on page 54.
Note
• When no image signal is input to the selected input
terminal, the message "No Input" is displayed on the
screen. (Refer to page 67.)
Basic Operations
/B-Y, P /R-Y)
B R
Projector
PC
VIDEO
Line Display
PC 1 COMP
PC 2 DVI
Y/C
VIDEO
33