Turning On The Power - JVC DLA-G150CLE Bedienungsanleitung

Basic Operations
I Projector's buttons
LAMP TEMP
OPERATE
HIDE
KEYSTONE
PRESET
EXIT
I Remote control unit
QUICK
ALIGN. OPERATE
HIDE
W W
SCREEN SCREEN FREEZE COMP VIDEO
S S
PC1 PC2 DVI Y/C
T T
DIGITAL
KEYSTONE ZOOM FOCUS
ZOOM
W W
PRESET MENU
EXIT ENTER
RM-M160 REMOTE CONTROL UNIT
32
STAND BY indicator
STAND BY
OPERATE indicator
OPERATE button
PC
VIDEO
MENU
ENTER
OPERATE button
The following describes the basic procedure for normal use
of the projector.

1. Turning on the Power

1
Turn on the MAIN POWER switch.
ON [ ❙ ❙ ❙ ❙ ]:The main power turns on and the STAND BY
indicator comes on.
2
Press the OPERATE button for one
second or more.
• The OPERATE indicator lights and the projected
screen slowly appears.
Remote control unit
OPERATE
Notes
• After the power is turned on, the image may be jumbled for
a few seconds, but this is not a malfunction.
• After the indicator comes on, it can take a minute or so for
the lamp to warm up and operate consistently.
I Turning off the Power
1
Press the OPERATE button for one
second or more.
• The STAND BY indicator changes to blinking, and the
projector goes into cool-down mode. The cool-down
mode will continue for approximately 120 seconds.
Remote control unit
OPERATE
Note
• The OPERATE button will not work for approximately 1
minute from when the light-source lamp is turned on. Use
the button after approximately 1 minute.
2
Turn off the MAIN POWER switch after
the STAND BY indicator changes to
steady on.
OFF [‡ ‡ ‡ ‡ ]:The MAIN POWER switch turns off and the
STAND BY indicator goes off.
CAUTION
• Do not turn off the MAIN POWER switch during cool-down
mode (the STAND BY indicator blinking). Turn it off after
the STAND BY indicator becomes on (stand-by mode).
Projector's indicator
STAND BY
OPERATE
Projector
STAND BY
OPERATE
or
(Blinking)
Projector
STAND BY
OPERATE
Projector
STAND BY
OPERATE