Checking The Engine-Oil Level; Adjusting The Handle Height; Adjusting The Cutting Height - Toro TurfMaster 22207 Bedienungsanleitung

Checking the Engine-Oil Level

Service Interval: Before each use or daily
Important:
If the oil level in the crankcase is too low or too high and you run the engine, you may
damage the engine.

Adjusting the Handle Height

You can raise or lower the handle in 1 of 3 positions that is more comfortable for you
1. Remove both handle bolts and corresponding nuts.
2. Move the handle to the desired height position.
3. Secure the handle with the previously removed bolts and corresponding nuts.

Adjusting the Cutting Height

The cutting height is controlled with a front lever and a rear lever, both on the left side of the machine. To raise
or lower the machine, engage the lever, raise or lower the machine, and then disengage the lever.
Figure 11
Figure 12
10
g235721
(Figure 12).
g235868