Makingcoffee With Ground Coffee - Electrolux ECG6600 Gebrauchsanweisung

822_949_354 ECG6600-East_Elux.book Seite 123 Freitag, 1. Februar 2008 11:36 23
below „Setting the jug programme
(Coffee strength and filling quantity
for the jug)" page 127.
0 If necessary, set the number of cups
that are to be made in the jug (4, 6, 8,
10 cups) with the scrolling buttons "<"
or ">" in steps of 2 cups.
3 If no button is pressed for a few sec-
onds, the appliance suggests the next
step in the display: «CHOOSE NUM-
BER OF COFFEE, PRESS JUG
KEY».
0 When you have selected the desired
number of cups, confirm this by press-
ing the "jug/cappuccino" button
(Figure 19).
The display shows a progress bar and a
percentage
«
which shows progress of the brewing
process.
When the progress bar is complete and
the percentage has reached 100%, the
appliance stops the brewing process
and automatically returns to coffee
mode.
0 Now remove the jug and close the lid
(Figure 20) to keep the coffee warm for
a long time.
If there are not enough coffee beans in
3
the container to complete the selected
function, the appliance interrupts the
process and waits until the coffee bean
container is filled back up and the "jug/
cappuccino" button
(Figure 19) is pressed. If, for
example, 8 cups need making but there
are only enough coffee beans for 6
cups, the appliance makes 6 cups and
then stops the coffee making process.
Fill up the coffee bean container and
then press the "jug/cappuccino" button
(Figure 19). Once this is done,
the appliance only makes the last 2
cups to complete the desired number
of 8 cups.
If there is either not enough water in
the water tank to complete the desired
function, or the waste coffee container
is full, the appliance interrupts the
process. In order to fill the water tank
or empty the waste coffee container,
the jug must be removed; the pro-
gramme that is running is interrupted
at this point. Once the problem has
been resolved, the programme has to
be restarted. At this point the amount
of coffee already in the jug must be
taken into account so as not to overfill
the jug.
9 Makingcoffee with ground
coffee
You can use this function to brew cof-
fee that is already ground, e.g. decaf-
feinated coffee.
40%»
1 Warning! Make sure that no ground
coffee is left in the chute. Also, no
foreign bodies must get into the chute.
The filling chute is not a storage con-
tainer, the ground coffee must go
straight to the brewing unit.
0 Turn the "coffee strength / preground
coffee" knob (Figure 21) to the
required position
tion for preground coffee. This puts the
coffee grinding mill out of action. The
appliance shows e.g.
«ESPRESSO CUP
PRE-GROUND 1 CUP».
0 Open the cover on the ground coffee
chute and fill it with fresh ground cof-
fee (Figure 22).
Only use the measuring spoon sup-
plied. Never put in more than 2 level
measuring spoonfuls, otherwise the
appliance either makes no coffee, the
ground coffee goes all round the appli-
ance and contaminates it, or the coffee
comes out in drips and the message
«GROUND TOO FINE
ADJUST MILL
+ PRESS HOT WATER KEY» is
displayed.
Do not insert any ground coffee during
the brewing process. Only once the
whole brewing process has ended and
(for 1 cup) or
(for 2 cups), to select the func-
g
123