Panasonic WV-CL930 Handbuch Seite 38

Advanced settings about motion detector function (MODE1)
The description below specifies the sensitivity level and detection area of the motion detector
(MODE1).
To perform mask setting, set the image stabilizer, i.e. "STABILIZER" to "OFF". ( page 44)
"CAMERA SETUP" screen
CAMERA ID
ALC/ELC
SHUTTER
AGC
SENS UP
SYNC
WHITE BAL
MOTION DET
DNR
RESOLUTION
BW MODE
LEVEL
DWELL TIME
DISPLAY MODE
MASK SET
RET TOP END
38
Downloaded from www.Manualslib.com
**CAMERA SETUP** 1/2
OFF
ALC
OFF
ON
OFF
INT
ATW1
OFF
HIGH
HIGH
"MODE 1" screen
**MODE1**
... | ...128
- +
2S
ALARM OFF
Mask setting screen
manuals search engine
Step 1
Set "MOTION DET" to "MODE1" and press the
setting button.
→ The "MODE1" screen appears.
Step 2
Move the cursor to "MASK SET" and press
the setting button.
→ The mask setting screen appears.
Step 3
Perform mask setting. Move the cursor to
"MASK SET" and press the setting button.
→ The mask setting screen appears.
Step 4
Hold down the setting button for approx.
more than 2 seconds after completion of
masking.
→ The "MODE1" screen appears again.
Step 5
Move the cursor to "ALARM", and decide
whether or not to provide an alarm signal in
the demonstration mode with use of "ON" or
"OFF".
ON: Provides an alarm signal output in the
demonstration mode, and allows users to
check the operation on the monitor when
a motion is detection.
OFF (default): Provides no alarm signal out-
put in the demonstration mode.