Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
PSB
Fault
Strong electrode burn-out • Pressure drop while cutting due to
Tab. 9
Troubleshooting
10 Dismounting
11 Disposal
11.1 Materials
11.2 Packaging
Cause
incorrectly set pressure monitor
• Loose electrode
• Pilot arc struck too long and too
frequently in air
DANGER
Risk of injury due to unexpected start-up.
For the entire duration of maintenance, servicing, dismounting and repair
work, the following instructions must be adhered to:
• Switch off the entire welding system.
NOTE
• Observe the information given in section 7 Putting out of operation on
page EN-15.
For disposal, observe the local regulations, laws, provisions, standards and
guidelines. Observe the guidelines for the disposal of electronic scrap and
dispose of it at your communal waste disposal authorities (e.g. recycling yard).
For the PSB to be properly disposed of, they first must be dismounted.
See 10 Dismounting on page EN-17
This product consists for the most part of plastics, steel and non-ferrous metals.
11 Disposal on page EN-17
ABICOR BINZEL has reduced the packaging for shipping to a minimum.
Packaging materials are always selected with regard to their possible recycling
ability.
10 Dismounting
Solution
• Correct pressure monitor setting
• Tighten electrode by hand
• Shorten/avoid ignitions in air if
possible
EN - 17
Werbung
Inhaltsverzeichnis
