GUTMANN Capa EM 0701 Bedienungsanleitung Seite 33

The activated carbon filters bind odours
in kitchen vapour. Depending on strain,
these filters must be replaced or regen-
erated after no more than 3 months. The
activated carbon filter is installed in a
frame to the left and right of the ventila-
tion module in the upper hood body. To
replace it, the metal filters must be taken
out and the hood swivelled down (on
this, see section "Replacing the metal
filter" + "Lighting replacement"). For this,
the lower body of the hood must be
swivelled down. Turn out the two screws
at the upper body of the hood and se-
cure the lower body of the hood with
one hand. After removing the two
screws, swivel down the lower body of
the hood slowly. The activated carbon
filters are kept in the upper hood body
with toggle locks. For replacement, loos-
en the toggle locks and remove the acti-
vated carbon filters diagonally down-
wards. Installation is performed in re-
verse order. Important: The activated
carbon filter must not be cleaned wet.
See sep. instructions "activated carbon".
The regeneration takes place in a pre-
heated oven (200 ° C) and takes 1-2
hours, depending on the level of odor-
ous substances. Caution, risk of burns!
Only take the activated charcoal filter
out of the oven after it has cooled down.
This can cause unpleasant odors in the
oven!
Caution: Never use the pyrolysis func-
tion!
Important: The activated charcoal filter
must not be cleaned wet. see separate
instructions for "activated carbon"
EN
33