Using Your Air Purifier; General Operation; Auto Mode; Air Quality Indicator - Levoit Tower True HEPA LV-H133 Bedienungsanleitung

U S I N G YO U R A I R P U R I F I E R

General Operation

1. Place the air purifier on a level surface.
[Figure 2.1] Leave 38 cm / 15 in of
clearance on all sides of the purifier.
[Figure 2.2]
2. Plug in. Tap to turn on the air
purifier. The fan will start automatically.
3. Optionally, tap
speed. You can also select Auto Mode
or Sleep Mode, or set a timer.
a. For best results, or to address a
specific air quality issue such as
smoke, run the air purifier at high
speed for 15–20 minutes before
using a lower speed or Auto Mode.
b. To effectively clean air, keep
windows and doors closed while
the air purifier is on.
4. Tap to turn off the air purifier.

Auto Mode

Auto Mode adjusts the fan speed
automatically based on air quality. For
example, if the air quality is bad, the fan will
be set to high speed.
• Tap to turn Auto Mode on/off.
• Tapping or
Mode.
Air Quality Indicator Chart
Indicator
Air Quality
Colour
Blue Very Good
Green Good
Orange Moderate
Red Bad
to change fan
will also exit Auto
Fan Speed
Sleep Mode
Low
Medium
High
Figure 2.1
38 cm /
15 in
Figure 2.2

Air Quality Indicator

This indicator uses an automatic sensor to
display the air quality. This sensor uses an
infrared light to detect airborne particles
The air purifier will take 30 seconds to
detect the air quality each time it is turned
on. During this time, the air quality indicator
colour will be blue. After 30 seconds, the air
quality indicator colour will change based
on the detected air quality.
EN
9