Using Your Air Purifier; About The Filter - Levoit Core 300 Bedienungsanleitung

EN
GETTING STARTED (CONT.)
3. Replace the filter cover and twist
clockwise to lock. [Figure 1.3]
4. Place the purifier on a flat, stable surface
with the display facing up. Allow at least
38 cm / 15 in of clearance on all sides
of the purifier. Keep away from anything
that would block airflow, such as curtains.
[Figure 1.4]
cover should
snap shut
Figure 1.3
38 cm /
15 in
38 cm
/ 15 in
Figure 1.4
10
U S I N G YO U R A I R
P U R I F I E R
1. Plug in and tap to turn on the air
purifier. The fan will start on level I.
[Figure 2.1]
2. Optionally, tap to change fan speed
between I, II, and III.
Note:
•
The indicators are not buttons and
cannot be used to change the fan speed.
•
The fan speed indicators will light up
when active.
• Fan speed III is the loudest, but cleans air
the quickest.
• For best results, or to address a specific
air quality issue such as smoke, run the
air purifier at high speed (level III) for
15–20 minutes before using a lower
speed.
•
To effectively clean air, keep windows
and doors closed while the air purifier
is on.
3. Tap to turn off the air purifier.
Figure 2.1
Memory Function
When the air purifier is plugged in, it will
remember its previous fan speed setting.
Note: The air purifier will not remember timers or
Sleep Mode.
USING YOUR AIR PURIFIER (CONT.)
Sleep Mode
Sleep Mode operates quietly by using the
lowest possible fan speed.
Tap to turn Sleep Mode on/off.
Note:
• All indicators will be at half brightness
while Sleep Mode is on.
• Tapping will exit Sleep Mode.
Timer
You can set a timer for 2, 4, 6, or 8 hours.
1. Tap repeatedly to select a time. The
timer will start automatically.
Note:
• The indicators are not buttons and
cannot be used to select a time.
• The timer indicators will light up blue
when active.
2. Once the timer has finished, the air
purifier will turn off.
3. To cancel a timer, tap until all timer
indicators are off.
Note:
•
You can change the fan speed at any
time while the timer is on.
•
The timer will restart if the time is
changed.
Display Lock
Locking the display prevents settings from
being accidentally changed. Buttons will not
respond to being tapped.
1. Tap and hold for 3 seconds to lock/
unlock the display.
Note: You can turn the display on and off
even if the display is locked.
A B O U T T H E F I LT E R
The air purifier uses a 3-stage filtration
system to purify air.
A
B
C
A. Pre-Filter
• Captures large particles such as dust,
lint, fibres, hair, and pet fur.
• Maximises the filter's life by
protecting it.
B. True HEPA Original Filter
• Removes at least 99.97% of airborne
particles 0.3 micrometres (µm) in
diameter.
• Filters small particles such as mould
spores, tiny dust particles, parts of
smoke, and allergens such as pollen,
dander, and mites.
C. High-Efficiency Activated Carbon Filter
• Physically adsorbs smoke, odours,
and fumes.
• Filters compounds such as
formaldehyde, benzene, ammonia,
hydrogen sulphide, and volatile
organic compounds (VOCs).
EN
11