SATA HF0414 Bedienungsanleitung Seite 10

Negative pressure wear airtightness check:
1） Cover the two air inlets on both sides of the filter cotton bracket with your palm.
2） Start inhalation, and if the mask body can be gently depressed against the face, and there is no air leakage between the cheeks
and the mask, it indicates that the airtightness is good.
3） If you feel the air leakage, re-adjust the position of the mask, or the tightness of the headband and neckband so as to eliminate the
air leakage. Repeat the above steps until the airtightness is good.
Daily cleaning, maintenance, storage and disposal:
1） Remove the filter and the cartridge, and if necessary, remove the headband and neckband.
2） Put the mask in soapy water, and gently brush and clean it. Do not use detergents that contain grease. In addition, the water
temperature must not exceed 40° C. The mask shall not be washed by using a washing machine or solvents.
3） If necessary, the mask can be put in sodium chlorate or other disinfectant solutions for disinfection.
4） Rinse it with water and allow it for air dry.
5） The filter cotton cannot be cleaned.
Maintenance:
Headband combination. Step 1. Remove the old headband from the plastic buckle by pushing the pressure head of the buckle and then
pulling the headband out of the buckle. Step 2. Insert a new headband into the opening on the side of the mask. Step 3. Insert the
headband into the pressure head of the plastic buckle.
Storage:
The mask body is made of silicone and shall be placed in a dry and ventilated environment away from dust, chemically corrosive
materials and high-temperature and squeezed conditions.
Disposal:
Dispose of the used respirator in accordance with local regulations. Any non-compliant disposal of filter cotton, cartridge and half mask
can damage the environment.
Product warranty:
"Superior SATA PPE". If you find any defects in the material, production and other performance quality problems of SATA PPE under the
premise of complying with the SATA written storage, maintenance and operating instructions, SATA will be responsible for repairing,
replacing or refunding the cost of the purchase of this product or any component.
Manufacturer：Nanhe Safety Equipment （Zhejiang）Co.,LTD
10
HF0414/HF0420
中文
EN DE RU KO PT JA ES