Connecting The Appliance To The Power Supply; Electrical Connections - AEG MCD2665E Benutzerhandbuch

164 www.aeg.com
IMPORTANT! Ensure the bottom
of the oven is 85 cm or more
above the floor. It is important to
ensure that the installation of this
product conforms to the
9.2 Connecting the appliance to the power supply
9.3 Electrical connections
WARNING!
THIS APPLIANCE MUST BE
EARTHED
The manufacturer declines any liability
should this safety measure not be
observed.
(A)
instructions in this operation
manual and the conventional oven
manufacturer's installation
instructions.
• The electrical outlet should be
readily accessible so that the unit can
be unplugged easily in an
emergency. Or it should be possible
to isolate the oven from the supply
by incorporating a switch in the fixed
wiring in accordance with the wiring
rules.
• The socket should not be positioned
behind the cupboard.
• The best position is above the
cupboard, see (A).
• Connect the appliance to a single
phase 230 V/50 Hz alternating current
via a correctly installed earth socket.
The socket must be fused with a 16 A
fuse.
• The power supply cord may only be
replaced by an electrician.
• Before installing, tie a piece of string
to the power supply cord to facilitate
connection to point (A) when the
appliance is being installed.
• When inserting the appliance into
the high-sided cupboard, DO NOT
crush the power supply cord.
• Do not immerse the power supply
cord or plug in water or any other
liquid.
If the plug that is fitted to your
appliance is not suitable for your socket
outlet, you must call your local AEG
service agent.