Connecting The Appliance To The Power Supply - AEG MW17E10M Benutzerhandbuch

9.2 Safe use of the appliance
If fitting the microwave in position B or C:
• The cupboard must be a minimum of
500 mm (E) above the worktop and
must not be installed directly above a
hob.
• This appliance has been tested and
approved for use near domestic gas,
electric and induction hobs only.
9.3 Connecting the appliance to the power supply
A)
• Sufficient space between hob and
microwave should be allowed to
prevent overheating of microwave
oven, surrounding cupboard and
accessories.
• Do not operate the hob without pans
when the microwave oven is
operating.
• Care should be taken when
attending to the microwave oven
while the hob is on.
• The electrical outlet should be
readily accessible so that the unit can
be unplugged easily in an
emergency. Or it should be possible
to isolate the oven from the supply
by incorporating a switch in the fixed
wiring in accordance with the wiring
rules.
• The socket should not be positioned
behind the cupboard.
• The best position is above the
cupboard, see (A).
• Connect the appliance to a single
phase 230 V/50 Hz alternating current
via a correctly installed earth socket.
The socket must be fused with a 10 A
fuse.
• The power supply cord may only be
replaced by an electrician.
• Before installing, tie a piece of string
to the power supply cord to facilitate
connection to point (A) when the
appliance is being installed.
• When inserting the appliance into
the high-sided cupboard, DO NOT
crush the power supply cord.
• Do not immerse the power supply
cord or plug in water or any other
liquid.
ENGLISH
123