Connecting The Appliance To The Power Supply - AEG MCD1763E Benutzerhandbuch

32 www.aeg.com
9.2 Safe use of the appliance
If fitting the microwave in position B or C:
• The cupboard must be a minimum of 500
mm (E) above the worktop and must not
be installed directly above a hob.
• This appliance has been tested and
approved for use near domestic gas,
electric and induction hobs only.
• Sufficient space between hob and
microwave should be allowed to
IMPORTANT! Ensure the bottom of
the oven is 85 cm or more above the
floor. It is important to ensure that the
installation of this product conforms
to the instructions in this operation
9.3 Connecting the appliance to the power supply
(A)
prevent overheating of microwave
oven, surrounding cupboard and
accessories.
• Do not operate the hob without pans
when the microwave oven is operating.
• Care should be taken when attending
to the microwave oven while the hob
is on.
manual and the conventional oven
manufacturer's installation
instructions.
• The electrical outlet should be readily
accessible so that the unit can be
unplugged easily in an emergency. Or it
should be possible to isolate the oven
from the supply by incorporating a switch
in the fixed wiring in accordance with the
wiring rules.
• The socket should not be positioned
behind the cupboard.
• The best position is above the
cupboard, see (A).
• Connect the appliance to a single
phase 230 V/50 Hz alternating current
via a correctly installed earth socket.
The socket must be fused with a 16 A
fuse.
• The power supply cord may only be
replaced by an electrician.
• Before installing, tie a piece of string to
the power supply cord to facilitate
connection to point (A) when the
appliance is being installed.
• When inserting the appliance into the
high-sided cupboard, DO NOT crush
the power supply cord.
• Do not immerse the power supply cord
or plug in water or any other liquid.