Use; Turning Off And Releasing From The Wheelchair - Klaxon KLICK electric-Serie Gebrauchsanleitung

During the use of the Cruise Control function it is compulsory to pay the utmost attention to road hazards in order to be able
DANGER
to intervene on the commands promptly avoiding any kind of collision that could cause damage to people and / or things.
Every action and/or tampering of the display to change performance and KLICK's security is strictly prohibited. The sole and
DANGER
only actions possible are those specified in paragraph 15.2 of this User's Manual.
NOTE: For further information on the display, see www.klaxon-klick.com or contact an authorised KLAXON dealer.

15.3 USE

Figure 62 shows the Standard handlebar of the Klick device and it identifies the elements that make it up (listed below).
1. Handlebar
2. Accelerator control
3. Reverse button
4. Display
5. Brake Lever
6. Display controls pushbutton panel
Once the device has been installed, the display has been turned on and a speed has been selected, use the accelerator control to make the device
start to move (Figure 31.1). To stop the device, use the brake lever. The KLICK brake is equipped with an additional safety device which deactivates
the motor when the lever is operated (Figure 31.2).
The device is equipped with reverse as standard equipment. To use reverse, press the red button once, then press the accelerator to start moving
the device backward.
To return to the forward operation, release the accelerator and push again the red button once.
The reverse button has only luminous warning systems to show whether it is selected or not.
This can occur in two ways:
VISUAL-> when button is lifted to the maximum then the reverse gear is DISENGAGED; when the button is turned to
CAUTION
maximum then the reverse gear is ENGAGED.
LUMINOUS > when the reverse gear is ENGAGED, the display flashes off and on repeatedly the backlight. When the reverse
gear is DISENGAGED this function stops responding.
After inserting the battery in its housing and locked by turning the key, remove it and put it in a safe place. It is absolutely
CAUTION
forbidden to use the KLICK device with the key insert in the security block.
The brake lever, the accelerator control, the reverse button, the display and the display controls pushbutton panel can be installed either on the left
or on the right side of the handlebar according to user's preference.
For installation and positioning of controls (display, accelerator control, reverse button, brake lever, display controls
DANGER
pushbutton panel), contact an authorised KLAXON service centre.
DANGER Before using reverse to move the device, make sure that there are no persons, obstacles, stairs, slopes behind the wheelchair.
At each restart pay maximum attention, before accelerating, to check if forward or reverse operation is currently selected,
DANGER
especially when close to obstacles, drop-offs and any other kind of danger.
If obstacles, drop-offs and dangers are too close to be safe, turn off the KLICK device and manually move the wheelchair to
DANGER
a safe place.

15.4 TURNING OFF AND RELEASING FROM THE WHEELCHAIR

To perform the operation properly, carefully follow the following instructions.
Stop the wheelchair on a flat surface.
Apply the brakes on the wheelchair.
Turn off the display by pressing and holding the "
Push the handlebar forward with one hand grasping it in the middle and simultaneously press the release button on the CONNECTOR with
the other hand. This frees the lower pin of the KLICK coupling (Figure 34).
Reduce forward pressure on the handlebar while holding the release button on the CONNECTOR, thus lowering the wheelchair so that its
front wheels make contact with the pavement (Figure 35).
At this point the upper pin will already be pulled out the front hook of the CONNECTOR; release the wheelchair's brakes and push yourself
back to move away from the KLICK device (which in the meantime will remain upright thanks to its KICKSTAND - Figure 36).
Remove the CONNECTOR, pulling the lever located on its bottom (Figure 20).
During the KLICK release operation, pay attention to not endanger the top parts of your body (fingers, hands, arms) as they
DANGER could be affected by the sudden movement of the handlebar (or other parts of the device) if it is released too quickly. To avoid
this danger, after pressing the release button, gently release the handlebar by lowering the wheelchair gradually.
KLAXON Mobility GmbH - ENG
POWER
" button for 5 seconds.
KLICK electric series Manual (ENG) - rev.6.3 of 25.05.2020
19