Herunterladen Inhalt Inhalt Diese Seite drucken

User Interface; Turning On And Setting Up The Device; Use - Klaxon KLICK electric-Serie Gebrauchsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Push the handlebar forward with one hand grasping it in the middle and simultaneously press the release button on the CONNECTOR with
the other hand. This frees the lower pin of the KLICK coupling (Figure 34).
Reduce forward pressure on the handlebar while holding the release button on the CONNECTOR, thus lowering the wheelchair so that its
front wheels make contact with the pavement (Figure 35).
At this point the upper pin will already be pulled out the front hook of the CONNECTOR; release the wheelchair's brakes and push yourself
back to move away from the KLICK device (which in the meantime will remain upright thanks to its KICKSTAND - Figure 36).
Remove the CONNECTOR, pulling the lever located on its bottom (Figure 20).
During the KLICK release operation, pay attention to not endanger the top parts of your body (fingers, hands, arms) as they
DANGER
could be affected by the sudden movement of the handlebar (or other parts of the device) if it is released too quickly. To avoid
this danger, after pressing the release button, gently release the handlebar by lowering the wheelchair gradually.
12. KLICK ELECTRIC TETRA VERSION / KLICK POWER TETRA VERSION OPERATION

12.1 USER INTERFACE

The device is equipped with a multifunction LCD display, used to switch the device on and off, select the maximum speed and display several
operating parameters (Figure 29).
The icon located top left (1) shows the current battery charge level.
The number (2) in the centre of the display shows the speed, in km/h.
The number (3) in the lower part of the display shows the distance travelled, in km.
The number (4) shows the desired maximum speed.
12.2 TURNING ON AND SETTING UP THE DEVICE (FIGURE 29).
A. Turning On and Selecting the Speed
Switch on the battery (for more information please refer to the instructions starting from section 18.3).
M
Press and hold the "
+
-
Press the "
" e "
" buttons to select the desired maximum speed level (viewable in the left panel of the display, number (5) in the legend);
various speed levels can be selected, between 0 (motor disabled), 1 (minimum speed, 3 km/h), 2 (normal speed, 6 km/h), 3 (medium speed,
10 km/h), 4 (high speed, 13 km/h) and 5 (maximum speed, 15 km/h).
B. Navigating the data
After turning on the display, the initial screen shows (in number 3) the total distance (ODO) the device has been used.
M
Press the "
" button once to enter the second screen. It will show the partial distance (TRIP - number 3).
M
Pressing the "
" button again for two times will display the time the device has been on, in minutes (TIME – number 3).
M
Pressing the "
" button again for three times will display the maximum speed (ODO MAX – number 2); pressing the "
display in the same screen the average speed (ODO AVG).
To reset trip data, hold down the "
C. Screen Backlighting
+
Hold the "
" button for 5 seconds to turn on the screen backlight.
To turn off the backlight, press the "
When the device is turned off, the light is also automatically switched off.
D. Speed Hold Function
-
Press the "
" button for 5 seconds to turn on the speed hold function. This function accelerates the device up to a speed of 4.5 km/h and
holds it as long as the button is pressed.
When the button is released, the device instantly stops accelerating.
Every action and/or tampering of the display to change performance and KLICK's security is strictly prohibited. The sole and
DANGER
only actions possible are those specified in paragraph 12.2 of this User's Manual.
NOTE: For further information on the display, see www.klaxon-klick.com or contact an authorised KLAXON dealer.

12.3 USE

Figure 37 shows the Tetra handlebar of the Klick device and it identifies the elements that make it up (listed below).
1.
Tetra handlebar with PUSH AND PULL acceleration/braking system.
2.
Display
3.
Reverse button
KLAXON Mobility GmbH - ENG
" button for 5 seconds, until the display turns on.
M
-
" and "
" buttons together for 5 seconds.
+
" button for 5 seconds again.
KLICK electric series Manual (ENG) - rev.6.3 of 25.05.2020
M
" button again will
13

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis