AGV PISTA GP RR Gebrauchsanleitung Seite 8

7 PINLOCK
®
ANTI-FOG LENS
A device made from a hydrophilic plastic with anti-fog characteristics capable of
absorbing moisture.
By precisely inserting itself into the specially-shaped slot on the inner surface of
the visor, it creates an air pocket that limits the onset of fogging without affecting
the field of view.
Anti-fog devices delay the formation of condensation but do not guarantee that the
phenomenon will not occur. This device delays the onset of the phenomenon. Therefore,
under extreme environmental conditions, the visor may still fog up.
We always recommend the use of Pinlock
and/or humidity levels above 70% and/or in the rain.
12 12
120
lenses with air temperatures below 20°C
®
7.1 INSTALLATION
Prerequisite: the visor is removed from the helmet
(see 4.2) and has been thoroughly cleaned. The lens
is resting on the inner surface of the visor, aligned
with the silicone gasket in contact with the visor.
Slightly stretch the visor, grasping it at the
•
ends (arrows).
Attach the lens (1) to the pins (2) of the visor;
•
first on one side, then on the other.
Ensure that the silicone gasket (3) of the lens
•
adheres perfectly to the visor along its entire
length.
Remove the protective film from the lens and
→
install the visor on the helmet (see 4.3).
7.2 REMOVAL
Prerequisite: the visor is removed from the helmet (see 4.2).
Slightly stretch the visor, grasping it at the ends (arrows).
•
Lift the lens (1) from its lower central part, then release it from the pins (2) on the visor; first
•
on one side, then on the other.
The lens is now detached. Remove it.
→
The Pinlock lens should be handled with care and without the use of tools that could
®
scratch it or abrade its surface.
7.3 PRETENSIONING
Consult the illustrative document included in the package of the Pinlock 120 lens.
®
1
2
3
EN
IT
FR
DE
ES
PT
РУ
中文 中文 中文
13 13