AGV PISTA GP RR Gebrauchsanleitung Seite 11

1
2
1
18 18
12 HYDRATION
Plastic water supply tube
Flexible rubber connector can be positioned in
three working positions
CamelBak BIG BITE VALVE
® ™
Locking screw and spacer washer
Plastic cup
12.1 INSTALLATION
The operation is easier if the wind protection
has been removed beforehand (see 10.1).
Prerequisite: use a Phillips-head screwdriver and sit
down with the helmet upside-down on your knees.
Insert the plastic tube (1) into the cheek pad,
•
then pull it out through the relevant opening
(arrow) in the seam of the fabric at the edge
of the cheek pad.
Connect the plastic tube with the rubber
•
connection (2).
Place the connection (2) on the inner surface
•
of the chinguard at the desired height, then
secure it with the screw (3), placing the spac-
er washer between the two.
Place the BIG BITE VALVE (4), linking it to the
• ™
rubber connection.
Connect the system to the hydration bladder
→
valve.
3
4
1
13 NOSEGUARD
2
13.1 REMOVAL
Prerequisite: sit down with the helmet upside-down
on your knees.
→
13.2 INSTALLATION
Prerequisite: sit down with the helmet upside-down
on your knees.
→
14 RESCUE PULL SYSTEM
To be used only in an emergency following an accident, the RPS allows for the rapid
removal of the cheek pads by first-aid personnel.
The mechanism works by way of two red straps placed below the cheek pads and con-
nected to the snap buttons that attach the cheek pads to the polystyrene shell. By pull-
ing on the straps, the snap buttons are released, thus allowing for the cheek pads to be
removed without first removing the helmet from the user's head.
14.1 ACTIVATION
Prerequisite: the helmet wearer is lying on the ground in a supine position.
Unfasten the retention system.
•
Pull on the two red straps - first one, then the other - until you feel the snap buttons release.
•
The cheek pad is now released from the helmet and can be removed.
→
Gently remove the cheek pad by moving the user's head as little as possible.
Never pull the red emergency straps whilst riding.
Do not remove the cheek pad via the RPS for maintenance.
Use only original AGV cheek pads.
Use the RPS only in an emergency.
Grasp the noseguard and detach it from its
slot, first releasing the side connection teeth
(1), then the central one (2).
Hook the noseguard into its slot, first inserting
the central connection tooth (2), then the two
side ones (1).
EN
IT
FR
DE
ES
PT
РУ
中文 中文 中文
19