AKG MicroMic C 417 III Bedienungshinweise Seite 15

The C 417
fore needs a power supply.
Using any power supply other than those
recommended by AKG may damage your
microphone and will void the warranty.
1. Connect the phantom power adapter (1) on the
microphone cable to a balanced XLR micro-
phone input with phantom power.
2. Switch the phantom power on. (Refer to the in-
struction manual of the unit to which you
connected your microphone.)
XLR
Fig. 1: Connecting to a balanced input.
3. If your mixer provides no phantom power:
Connect the phantom power adapter (1) to an
optional AKG phantom power supply (2) (N 62 E,
N 66 E, B 18, B 15) and use an XLR cable (3)
(e.g., an optional MK 9/10 from AKG) to connect
the phantom power supply to the desired
balanced input.
You may connect any AKG phantom power sup-
ply (2) to an unbalanced input, too.
Use a cable (3) with a female XLR connector and
TS jack plug:
Downloaded from www.Manualslib.com
is a condenser microphone and there-
III
Phantom
1
2
manuals search engine
2 Interfacing
2.1 Introduction
Important!
2.2 C 417
2.2.1 Connecting
to Balanced
Inputs
Refer to fig. 1.
XLR
1
3
Refer to fig. 1.
2.2.2 Connecting
to Unbalanced
Inputs
Refer to fig. 2.
PP
III
15